VIRTUALBOX BRIDGED ADAPTER SOFTWARE

The point here is to make sure all interface that you need for bridge is Lo: mtu 16436 qdisc noqueue state UNKNOWNĮth0: mtu 1500 qdisc pfifo_fast state UP qlen 1000Įth1: mtu 1500 qdisc pfifo_fast state UP qlen 1000īr0: mtu 1500 qdisc noqueue state UNKNOWN You should see at least four network interface, with output look like these,

Then, run these command to test the configuration:Ĭheck the new configuration of the network devices

# file: /etc/sysconfig/network/ifcfg-eth1 # file: /etc/sysconfig/network/ifcfg-eth0 Requirement or topology, in this illustration the configuration will be look eth1 (3Com 3c905 PCI ethernet - intended for the bridge)Īs 'root' edit/create the files below or configure them based on your network.eth0 (Marvell 88E8001 Asus on-board ethernet, intended as the 'main'.Desktop system/server running OpenSuse 10.3 (static IP 192.168.1.2).LinkSys router (as gateway 192.168.1.1 with DHCP capabilities).System Scenario for Illustration Scenario I : Bridging With Two Network Card The information in each of the ifcfg-*** files is described in the SLEDĭocumentation and documented in the template file included in your OpenSuSE Up and both host and guest machine connected, try to turn on the firewall The firewall before create the bridge connection. The OpenSuSE firewall can interfere with bridging.īe sure to take care of this to ensure that it is not the firewall that is

VIRTUALBOX BRIDGED ADAPTER SOFTWARE

You can search the software packages here Basics of Bridging in OpenSuSE 10.3

user mode linux utilities (package name : uml-utilities).

bridge utilities (package name : bridge-utils).

1.3.2 Scenario II : Bridging With One Network Card and One Virtual Network card.

1.3.1 Scenario I : Bridging With Two Network Card.

1.2 Basics of Bridging in OpenSuSE 10.3.

Virtualbox bridged adapter